Strata CTX670 Installation

Install Reserve Power

Cabinet Floor Mounting

The part numbers and descriptions of the floor mounting hardware are shown in Table 4-6.

Table 4-6 Floor Mount Hardware

Option

Description

 

CTX670 conduit connection box that is installed in the base cabinet, side panel. It is used to

 

hardwire Primary AC power and reserve battery power connections through conduit. These

 

boxes are required by UL for three or more floor mounted cabinets. Conduit boxes are not

BCCB120 or

required for wall mounted systems with any number of cabinets or floor mounted system with

one or two cabinets. They can be used as an option on any system.

BCCB240

The BCCB120 is required when connecting AC120VAC as the primary power source and the

 

 

BCCB240 is required when connecting AC208VAC or AC240VAC as the primary power

 

source.

 

BCCB conduit boxes must be field installed by a certified electrician.

 

 

 

Floor mount fixture kit is required when floor mounting two or more CTX670 cabinets.

BFIF

Provides two metal stands for mounting any number of CTX670 cabinets on floor. Three

pairs or wall brackets (RWBF) are supplied with BFIF to use when mounting three or more

 

CTX670 cabinets on floor. The wall brackets are needed to secure floor-mounted systems to

 

the wall for safety purposes.

 

 

Floor Mounting One or Two Cabinets

1.Remove front, side, and top covers from cabinet(s) (Figure 4-5). Remove plastic locating parts from all cabinet back covers using a Phillips screwdriver.

2.Make sure that cabinet power supplies (BPSU672A) are installed per “Install Power Supply” on page 4-6.

3.If installing just one or two cabinets, install the BFIF fixtures on each side of the bottom of the cabinet (Figure 4-19) and place the cabinet where it should be installed.

4.Set the bottom cabinet on the floor or mount surface, then set the top cabinet on the bottom cabinet.

5.Fasten the two cabinets together with the four screws provided: (two screws at front “A” and two at back “B” of cabinet. Place cabinet where it should be installed.

6.Connect the Expansion Cabinet data cable to the “CAB. 2” data cable connector on the Base Cabinet (Figures 4-9and 4-12).

...or if installing a Remote Expansion Cabinet: see details in “Remote Cabinet Installation Instructions” on page 4-56.

7.Install ground wiring, AC and reserve power cabling, and PCB cabling per the “Recommended Installation Sequence” on page 4-6.

8.Fill out cabinet/slot identification labels on cabinet(s) (Figure 4-8).

9.Reinstall covers on to cabinets (Figure 4-5).

Installation

Strata CTX670

 

 

Strata CTX I&M 06/04

4-33

Page 159
Image 159
Toshiba CTX28 manual Cabinet Floor Mounting, Floor Mounting One or Two Cabinets, BCCB240, Bfif