Toshiba CTX28 manual Busy/Idle On = Busy OFF = Idle

CTX28 Installation

Installing the CTX28 Cabinet

Status LED

VM Port LEDS

(Ch1 ~ Ch4)

Busy/Idle

RS232C
Maintenance
Jack
Note: For details, see
GVMU Admin PC
Connections later in	SW6 - Battery Jumper
this chapter.

7395

SW2 - Language Jumper

SW3 - Language Jumper

SW4 - Admin PC/Debug Monit

SW5 - Not Used

CTX28 Installation

Figure 1-9 Close Up of PCB Stopper for GCTU and GVMU

Table 1-7 LED Indicators on the GVMU1A

Indication/ State			GVMU1A LEDs
	Ch1	Ch2	Ch3	Ch4	Status
Power On	All LEDs turn ON (Red), then all LEDs turn OFF and cycle ON/OFF through all ports
(Initialize Sequence*)	for one to two minutes while initializing and then all LEDs turn off.
Normal	OFF	OFF	OFF	OFF	Blinking
(Busy/Idle)		ON = Busy; OFF = Idle
Failure	Blinking	Blinking	Blinking	Blinking	OFF
Shut Down	ON	ON	ON	ON	OFF
Back Up/Restore	ON	ON	ON	ON	ON
No 1.8V input Voltage	ON	OFF	OFF	ON	ON
in GVMU
Not mounted/defective	Light flickers and switches from the LED to LED (from Ch1~Ch4) + Status LED

*The initialize sequence operates each time the CTX28 power is cycled off/on or the CTX28 processor is reset or initialized – GVMU program data remains saved. However, if the GVMU battery jumper is removed, GVMU program data and saved messages will be erased.

Strata CTX I&M 06/04 1-13