Strata CTX100-S/CTX100 Installation

Installing the CTX100 Cabinet

Step 13: Mount the Expansion Cabinet (if required)

WARNING! To prevent electrical shock, make sure the power supply is not plugged into the AC outlet.

1.Turn Base Cabinet DC power switch Off. Remove the four screws on the right side cover of the Base Cabinet.

2.Remove four screws from the right side of the Base Cabinet (since they will interfere with attaching the Expansion Cabinet to the Base Cabinet later).

3.Remove the Expansion Cabinet back cover from the Expansion Cabinet (see Figure 3-4).

4.Place the Expansion Cabinet back cover next to the Base Cabinet back cover, making sure expansion back cover hooks fit into the base back cover flanges (see Figure 3-5).

5.Mark the location of the four screw holes – there is one on each corner.

Make sure the location of the Expansion Cabinet meets the minimum clearance requirements specified in Figure 3-1 on page 3-3.

6.Drill holes on these marks.

7.Place the Expansion Cabinet back cover on the wall back board and secure the back cover to the back board with four screws.

8.On the right side of the AMAU motherboard inside the Base Cabinet, flip open the top and bottom locks for data ribbon cable plug. Plug in the data ribbon and close the locks. Feed the ribbon through the side hole of the Base Cabinet.

9.To mount the Expansion Cabinet, position it onto the back cover hangers.

Note Position the cabinet over the bottom right hanger first, and then carefully tilt the cover over the top two hangers.

10.Slide the Expansion Cabinet to the left, feeding the data ribbon cable through the side hole of the Expansion Cabinet.

11.Finish by securing the Expansion Cabinet to the Base cabinet with the two screws in front of the cabinets where they join together. The expansion cabinet left-side flange fits over the Base cabinet right side flange (see Figure 3-7).

12.On the AMAU motherboard of the Expansion Cabinet, flip open the two data ribbon locks, plug in the data ribbon and close the locks. The data ribbon cable should now be connected to the Base and Expansion cabinets.

13.Install PCBs into the Expansion Cabinet; follow the instructions in “Step 18: Install Other PCBs into the Cabinet(s)”.

Note The Base Cabinet DC power switch will be the master control for turning the DC power of both cabinets On/Off.

14. Attach the outside covers on the Expansion Cabinet.

CTX100 Installation

Strata CTX100-S/

 

 

Strata CTX I&M 06/04

3-9

Page 111
Image 111
Toshiba CTX28 manual Mount the Expansion Cabinet if required