Rack Mount Cabinets

Step 7: Verify Power Supply Settings

Step 7: Verify Power Supply Settings

If the cabinet is the Base Unit set the Exp/Base switch to the “Base” position (see “Power Supply Unit (BRPSU672A)” on page 5-28).

...or if the cabinet is an Expansion Unit, set the Exp/Base switch to the “Exp” position.

Important! The power supply set as “Base” is the master and has On/Off control over all other power supplies, which are designated as slaves. If the master power supply is turned Off or On, all other power supplies will automatically turn Off or On. (Individual slave power supplies must be turned On.)

Step 8: Fill Out Slot Assignments

The slot identification label appears on the lower right side of the cabinet interior (shown below).

Base Cabinet

Expansion Cabinet

6999

B101

B102

S101

S102

S103

 

 

 

 

 

S104

S105

S106

S107

S108

 

 

 

 

 

6998

CABINET NO.

2 3 4 5 6 7

S_01 S_02 S_03 S_04 S_05

S_06 S_07 S_08 S_09 S_10

Step 9: Attach Mesh Tie (B50MT)

Wrap the cables in with the mesh tie. The purpose of the wrap is to shield the cables from EMI/RFI effects. See Figures 5-6, 5-7and 3-10 for additional information.

Note One mesh tie is required to wrap cables individually in each cabinet. One mesh tie is required to wrap all cables where they exit the system. A B50MT Mesh Tie is included with each base and expansion cabinet.

5-12

Strata CTX I&M 06/04

Page 200
Image 200
Toshiba CTX28 manual Verify Power Supply Settings