Toshiba CTX28 manual Set Jumpers and Install Option PCBs onto the Actu, To install the ACTU2A

Strata CTX100-S/CTX100 Installation

Installing the CTX100 Cabinet

Step 16: Set Jumpers and Install Option PCBs onto the ACTU

To install the ACTU2A

Refer to Figure 3-18and perform the following steps on the ACTU2A.

1.Set the battery jumper, “BATT,” to the “On” position.

2.Make sure the WDT jumper plug is set to the ON position.

Note Unlike the ACTU1A, the ACTU2A does not use the AETS or the ARCS option PCBs. NIC and DTMF circuits are built into the ACTU2.

3.Install needed option PCBs onto the ACTU (AMDS, BSIS).

4.Place option PCB arrow side up over the plastic stand-offs with the connectors and stand-off holes on the ACTU. Snap option PCB securely into place.

5.Insert the SmartMedia card (gold contacts face left, notched corner faces forward and up) into the SmartMedia slot on the ACTU.

6.Make sure the power supply switch is Off.

7.Install the ACTU into the Base Cabinet (see following photos).

Notes

•ACTU2A requires R1.3 software or later.

•MOH/BGM source volume is controlled by software PAD in Program 107-01, 02 and 03. Mu/ A law must be set to Mu law in software Program 105-35 for North America.

•For details on jumpers and add-ons (subassemblies) for the ACTU, see Table 3-2 on page 3-22.

CTX100 Installation Strata CTX100-S/

ACTU2

SmartMedia Card	SmartMedia
	Slot

Metal Spacer

Note: The ACTU1A is a larger board and does not have the metal spacer.

P4

BSIS1A	P6
(RS232-C, SMDR and SMDI)
10 Base-T Ethernet	R806
	P3
ASTU plugs into P3

Control Relay Terminal (Night Transfer, etc.)

Future MOH2 Jack MOH2 MOH/BGM1 RCA Jack MOH1 600 ohm page output EXSP

Figure 3-17 ACTU2A PCB (CTX100 Processor)

P2

Place

BSIS here

600/600 600/600 600/600

P5
	BATT
OFF	ON	Battery
	P601	Backup
		Jumper
Place
AMDS
here

6636

Strata CTX I&M 06/04 3-19