Toshiba CTX28 manual Tilt Stand Installation with Add-on Modules, 11-24

Station Apparatus

Tilt Stands

Tilt Stand Installation with Add-on Modules

This section explains how to attach a tilt stand to a digital or IP telephone with one or two ADMs. Follow the instructions for the appropriate number of ADMs. Use Tilt Stand model “BTSA” (not “BTSD”) for telephones with one or two ADMs.

To attach a digital or IP telephone with one ADM to a Tilt Stand

1.Complete the steps under “To install DADMs” on page 11-21.

2.Make sure bottom phone jack is plugged in.

3.Remove Tilt Stand from Tilt Stand Base (see Figure 11-21).

4.Place the spacers on the outer holes, as shown (see Figure 11-22).

5.Attach Tilt Stand to bottom of telephone with screws (see Figure 11-20).

6.Reinstall the Tilt Stand Base: Fit the Tilt Stand Base over the Tilt Stand so that the “bottom pegs” fit into the holder. Adjust Tilt Stand so that the “top pegs” fit into the top Tilt Stand Base holes (see Figure 11-21). Do this to both stands.

7.Pull up on the Tilt Stand Bases so that they open to the maximum angle (30 degrees).

8.Push in the Release button to adjust the tilt angle (0, 10, 20 or 30 degrees) of each Tilt Stand.

1 ADM + 1 DKT (or 1 IPT)

ADM DKT/IPT

Spacer

1 ADM PHONE			PHONE
2 ADM
1 ADM	PHONE	1 ADM
2 ADM			2 ADM

		Spacer
1 ADM	1 PHONE	PHONE
2 ADM

1 ADM

2 ADM PHONE 1 ADM 2 ADM

6506

Put in three screws in the	Put in three screws in the
positions marked “1ADM.”	positions marked “PHONE.”

Insert a spacer beneath each stand as shown. Put in the screw with the spacer first. Then insert the other two screws.

Figure 11-20 Attach Tilt Stands to DKT/IPT and One ADM

11-24 Strata CTX I&M 06/04