Station Apparatus

2000-series Telephones

To toggle full/half-duplex mode

Press button 10 (see Figure 11-41) to turn full-duplex mode On or Off.

Full-duplex mode: Button 10 LED Off.

Half-duplex mode: Button 10 LED On.

Notes

Button 10 functions the same for Internal and/or External Microphone.

If DIP switch 6 and 7, in Figure 12, are turned Off, the Full/half-duplex function of Button 10 is disabled.

The DKT2020-FDSP’s full-duplex operation depends on the speaker volume setting. Raising or lowering the speaker volume directly affects the performance of the full-duplex operation.

Important!

If raising or lowering the volume does not improve performance, switch to half-duplex mode by pressing Key 10.

If both you and the distant party are using full-duplex speakerphones, the sensitivity to both echo paths may cause a reduction or instability of volume. If this happens, it may be necessary to switch to half-duplex mode by pressing key 10.

Digital Single Line Telephone (DKT2001 only)

For instructions on installing the DKT3001 SLT, see “Digital Telephone System Connection” on page 11-2.

DKT 2001 Installation

1.Set the DIP switches to match Figure

11-42. The DIP switches are preset from the factory for the USA and Canada. Refer to Table 11-10 on page 11-52for other country settings.

2.If required to achieve maximum distance (greater than 1000 ft.), install a two-pair house cable (or external power).

ON

1 2 3 4

4

Station Apparatus

3482

Figure 11-42 DKT2001 DIP Switch Settings

Strata CTX I&M 06/04

11-57

Page 455
Image 455
Toshiba CTX28 Digital Single Line Telephone DKT2001 only, 11-57, To toggle full/half-duplex mode, DKT 2001 Installation