Toshiba CTX28 manual To wall mount IP telephones, Handset Hanger

IP Telephony and QSIG Over IP

Pre-installation Guidelines

To wall mount IP telephones

Refer to Figures 9-5~9-7and the following steps.

1.Loosen the captive screws, and remove the telephone base.

2.Using a suitable cutter, remove the handset hanger from the base.

3.Insert the handset hanger in the slot on the front of the phone. It fits in the notch on the cradle.

4.Carefully remove the IPT10-SUB from the base unit by pulling back the plastic clips that hold it in place (see Figure 9-4).

Handset Hanger

1479

Figure 9-5 Handset Hanger

5.Rotate the IPT10-SUB 180 degrees. Secure it back onto the telephone PCB with the white plastic clips (see Figure 9-6)

Push in clips to secure

IPT10-SUB.

J200

J201

LED Port

IPT10-SUB should be turned this way (180 degrees from original placement) for wall

mounting the telephone.

ADM

P101
UARTO
		SUB-IPT10
			J502
J402 HEADSET		W403	W400 CARBON
CARBON	W402
CARBON	W401		CARBON

IPT10-20KSD

6751

Figure 9-6 Rotate IPT10-SUB for Wall Mounting

6. Rotate the telephone base 180 degrees and secure

it to the telephone with its four captive screws (see Figure 9-7)

7. Connect the phone to the wall modular connector with a cord approximately four inches long (available at most telephone supply companies).

8. Route the cord into the hollow portion of the base.

9. Mount the phone on the wall mounting modular connector plate.

1480

Figure 9-7 Wall Mounting Base Rotation

9-12 Strata CTX I&M 06/04