Rack Mount Cabinets

Step 3: Install Remaining Cabinet(s)

Step 2D: Reattach Cabinet to Base

Note Skip this step if you did not perform Step 2B.

Using the two screws removed in “Step 2B: Take Off Base of Cabinet” on page 6, reattach the cabinet to the base.

Step 3: Install Remaining Cabinet(s)

Step 3A: Take Off Front and Back Covers

1.Unscrew the two screws holding the front cover to the unit and slide the cover off.

2.Unscrew the four screws holding the back cover to the unit and take the cover off.

Step 3B: Install and Attach Cabinet(s) to Rack

Note See “Step 2C: Attach Cabinet to Rack” on page 5-6for special instructions on positioning the cabinets before attaching.

1.Place the base of the next cabinet 10.5 inches from the base of the upper base/expansion cabinet (as shown below).

Start (see Fig. 4-3)

6U = 10.5 inch or 267 mm

Start (see Fig. 4-3)

7101

2. Screw the cabinet flange to the rack using two screws on each flange (four total).

5-8

Strata CTX I&M 06/04

Page 196
Image 196
Toshiba CTX28 manual Reattach Cabinet to Base, Install and Attach Cabinets to Rack