3.Place the Base KSU on the desired location on the mounting surface and mark the location of the four screw holes. See Figures 1-4and 1-5.

4.Using a hard board between the KSU and the wall, secure the hard board to the wall first, making certain that screws are aligned with studs. See Figure 1-5.

5.Drill holes on these marks and secure screws approximately two thirds of the way into the top two holes on the mounting surface.

6.Hang the unit from the top two screws and then secure the top screws completely into the mounting surface.

7.Finish securing the unit to the mounting surface by completely screwing the bottom two screws into the wall.

CTX28 Installation

Installing the CTX28 Cabinet

CTX28 Installation

7104

Figure 1-4 CTX28 Base KSU Interior

Plaster

Method 2

Stud

Board

 

Hard Board

(1/2 Inch Plywood)

Base KSU

7114

Figure 1-5 KSU Wall Mounting

8. Ground system according to “AC Power and Grounding Requirements” on page 1-4.

Strata CTX I&M 06/04

1-7

Page 27
Image 27
Toshiba manual CTX28 Base KSU Interior