Toshiba CTX28 manual RDTU3A Call Data Information, Commands

T1

RDTU3A Call Data Information

RDTU3A Call Data Information

RDTU3A has an RS-232C port to trace data that the RDTU3A sends and receives from the CTX system processor. The T1 line alarm data can also be monitored with the RDTU3.

Commands

You can type the commands in the following table to check the status indicators also described in the table below.

Table 8-7 RDTU3 Status Commands

Command	Function	Format	Indication
			RDTU3A © TOSHIBA 2002 VER.1A
			UNIT MODE:FFMxx SCHxx TSxx RPDxxxx TPDxxxx
	When you power		ZCSxx
			ERR:CRCyyy SLPyyy FSYyyyy BPVyyyyy
	On or when you
			ALARM:YA on/off BA on/off FSL on/off
U	enter “U,” the unit	u [RTN]
	name and software		CRC = CRC Error in ESF mode
	version appears.		SLP = Slip error
			FSY = Frame Sync error
			BPV = Bipolar violation error
			CH.vv : DTxx DRyy DDTon/off
			CH MODE: Ax
			Explanation:
			CH.vv:vv = channel numbers 0~23
			DTxx:xx = DHin data code for RDTU3A to RCTU (see Table
			8-9)
		C v [RTN]	DTyy:yy = DHout datacode RCTU to RDTU3A (see Table
			8-10)
		v = 0 to 23
	Channel mode		DDTon/off:
CH
	check command		DDT1 = RDTU cannot receive requests from the central
		Note: H = 1
		or 0	processor at this time (see following Notes).
			DDT0 = RDTU is available to receive requests from the
			central processor
			CH MODE:
			A8 = CO loop, A0 = CP grpimd. AA = Tie immediate, AB =
			Tie Wink, AC = DID Immediate, AD = DID WInk
			This information is the same as “2-2 Data-HWY code” and
			“2-5 Channel Trunk Type information.”
	Set RDTU3A into
	the Remote Loop
	Back mode
Loop back	Useful for checking	L [RTN]	L
	remote equipment.
	When RDTU3A is in
	this mode, BSY
	LED will flush.
Quit Loop	Quit Loop back	Q [RTN]	Q
back	mode

8-10 Strata CTX I&M 06/04