Toshiba CTX28 manual CTX670 License Control, CTX670 Processor PCB Subassemblies

Strata CTX Configuration

CTX670 License Control

CTX670 Processor PCB Subassemblies

Subassemblies can be added to the BCTU processor PCB to provide additional features. The subassemblies are:

•AMDS (Modem) – Provides a 33.6Kbps/V.34 modem for point-to-point local or remote connection to the CTX WinAdminTM administration PC.

•BSIS interface PCB which attaches to the BCTU to provide up to four RS-232 interface ports for SMDR Call Accounting and SMDI or Toshiba Proprietary Voice Mail interface.

See Table 2-3 on page 2-9for the number of cabinets and universal PCB slots for the Basic and Expanded systems.

CTX670 License Control

The system size and feature capability is controlled using a software License Key Code. This key code is obtained from the Toshiba Internet FYI site during the ordering process and is installed onto the system processor via Strata CTX WinAdmin. Processor license codes activate system hardware capacities in the following increments.

•The first 64 line/station ports do not require a license. Each additional set of four line/station ports requires one LIC670-4PORTS license (maximum of 672 ports).

•The on-board DTMF receiver circuit provides up to 32 DTMF receiver hardware circuits. The first four DTMF circuits do not require a license. Each additional set of four DTMF receiver circuits requires one LIC670-4DTMF license (max. total of 32 DTMF circuits).

Note DTMF tone receiver circuits are required for standard telephones, Voice Mail DTMF integration, Tie, DID and DNIS line service.

•The optional RS-232 serial port interface (BSIS) provides two circuits to interface with Voice Mail SMDI or Toshiba Proprietary Voice Mail integration, Call Accounting SMDR, and two for future applications. The first circuit does not require a license, but circuits two through four each require one LIC670-SER PORT license.

Licensed Software Options

Some software options are activated with license codes. The following software options require a license:

•Each CTX system (node) in a Strata Net QSIG Network requires one LIC670-QSIG NET license. A maximum of four serial network nodes are allowed in any one serial chain in the network topology.

•Each individual CTI Open Architecture application requires one LIC670-CSTA AP license (maximum nine).

Strata CTX Configuration

Strata CTX I&M 06/04 2-7