Xante 3 Series warranty Linearization Window

•Printing a Calibration Page

•Using the Densitometer

•Linearizing the Densitometer Data

Printing a Calibration Page

To begin calibrating your printer, print a calibration page to measure the printer’s current performance as a basis for the calibration.

1.Open XANTÉ Command Center and choose Controller: Linearize. The Linearization window appears (fig. 4.23).

Fig. 4.23 Linearization Window

2.Change the Linearization window LPI setting in the Print box (fig. 4.23) to achieve 256 levels of gray for the resolution at which you are printing.

Note: For 600 dpi, select 85 lpi; for 1200 dpi, select 106 lpi; for 2400 dpi, select 133 to 150 lpi. Any lpi may be

used; measure the lpi that is to be used for final output.

3.	Print a Calibration Page to m	easure the printer’s current
	performance as a basis for the calibration. To do this		use the
	following procedure:

___________________________________________ PC Setup 4-37