Xante 3 Series warranty Configure the Novell Print Server Interface, Printer displays

Note:	The printer enters a waiting state while it saves
	the file server name. Do not proceed until the
	printer displays	READY/IDLE.

5.If a password is required to access the file server, change the print server password to agree with the password set up on the file server.

Note: If no password is required to access the Novell server, this step is not required.

a.Choose Networking: Novell Print Server: Set Print Server Password.

b.Type in the password exactly as it was entered on the file server; then click Ok to return to the main menu. The password is case sensitive and must follow Novell NetWare naming conventions.

Note:	The printer enters a waiting state while it saves
	the file server name. Do not proceed until the
	printer displays	READY/IDLE.

6.Repeat steps 2 through 5 to add up to four file servers.

7.Print a start-up page by taking the printer off line, pressing the front panel Test button, and then putting the printer back on line. Check the page to be sure the new print server name is enabled.

8.Go to “Configure the Novell Print Server Interface” later in this chapter to continue configuration. To complete configuration

using printer front panel menus rather than XANTÉ Command Center, choose File: Quit to close Command Center.

Configure the Novell Print Server Interface

Use XANTÉ Command Center and printer front panel menus to enable your printer’s Novell Print Server interface and to configure timeout and frame type options for your network environment.

_______________________________________ Ethernet Setup 5-19