Xante 3 Series warranty PC TCP/IP Address Window

Using XANTÉ Command Center (PC)

Note:	Your PC	must	be directly connected to the printer through a
	parallel or serial cable to use XANTÉ Command Center.
	You cannot		set the commands through a network.

1.If necessary, enable the Line Printer interface using printer front panel menus. See “Interface Control” in chapter 6.

2.Open XANTÉ Command Center by double-clicking its icon.

3.Choose Controller: General: TCP/IP Address.

Fig. 5.20 PC TCP/IP Address Window

4.If necessary (check with your System Supervisor), change the network class by clicking the appropriate option button.

5.Change the printer’s default TCP/IP address to the address

assigned by your System Supervisor using the scroll bars under each octet.

6.Click OK. The main menu reappears.

7.Choose File: Exit. Command Center closes.

8.Restart the printer to make the new TCP/IP address take effect.

Using XANTÉ Command Center (Macintosh)

1.Open XANTÉ Command Center by double-clicking its icon.

5-26 Ethernet Setup ______________________________________