Removing the Duplexer

Warning: The fuser becomes very hot during operation. To avoid burns, turn the printer off and allow it to cool for at least 40 minutes before touching any area with a high-temperature warning label (fig. 10.19).

1.Make sure the printer displays a PLEASE WAIT or READY/IDLE message. Then, turn off the printer and disconnect the power cord from the power supply (fig. 2.6).

2.Remove all media from the multipurpose feeder and output tray.

3.Remove the paper guide (fig. 10.26).

4.Loosen the screws holding the duplexer cable to the printer; then disconnect the cable (fig. 10.25).

5.Loosen the screws holding the duplexer to the printer (fig. 10.24).

6.Lift the duplexer off of the printer and set the duplexer on its back.

7.Align the duplex access panel top tabs in the notches on the top of the fuser cover; snap the bottom tabs into place (fig. 10.27), and close the fuser cover.

Caution: To prevent burns and paper jams, do not use the printer with the duplex access panel removed unless the duplexer is installed.

10-24 Options __________________________________________

Page 272
Image 272
Xante 3 Series warranty Removing the Duplexer