Xante 3 Series warranty Open the Latches and Remove the Simm

1.Remove the controller board panel following the instructions earlier in this section.

2.Unpack the SIMM or SODIMM.

3.Remove the existing SIMM(s) or SODIMM if necessary using the following procedure (fig. 10.32).

a.Pull open the latches on each end of the SIMM or SODIMM bank.

Note: As the SIMM is released by the latches, it tilts out of the bank (fig. 10.32). A SODIMM does not tilt (fig. 10.33)

b.Pull the SIMM out at a 45° angle or a SODIMM straight up and out of the bank.

Fig. 10.32 Open the Latches and Remove the SIMM

10-30 Options __________________________________________