Xante 3 Series Configure the Print Server Emulation, Using Xanté Command Center PC, Your PC

20.Enable Novell Print Server on the printer’s front panel using the following procedure.

a.Press the Online key once to take the printer offline.

b.Press the Menu key until SETUP:I/F appears; then, press the Enter key.

c.Press the Menu key until I/F:NVL PSRV appears; then press the Enter key. NVL PSRV:ENABLE appears.

d.Press the Enter key. Then, press the Menu key until ENABLE:yes appears.

e.Press the Enter key. Then press the Online key.

The Novell server is now configured for NetWare version 5.X.

Configure the Print Server Emulation

Following the file server setup, the Novell System Administrator assigns the printer a list of file servers to poll and gives it the login name and password (if required) to access each server. This section describes configuring the print server emulation using XANTÉ Command Center. See your Novell NetWare documentation if you

prefer to use that application. See chapter 3 (Macintosh) or 4 (PC) to install and configure Command Center on your host computer.

Using XANTÉ Command Center (PC)

Note:	Your PC	must	be directly connected to the printer through a
	parallel or serial cable to use XANTÉ Command Center.
	You cannot		set the commands through a network.

1.Open XANTÉ Command Center by double-clicking its icon.

2.Choose Controller: Novell: Add File Server.

_______________________________________ Ethernet Setup 5-15