Xante 3 Series warranty Configure the Novell Server NetWare 3.X, Start-up

To configure the Novell server for NetWare versions 3.X or 4.X see the next section; for version 5.X, skip to “Configure the Novell Server (NetWare 5.X)” later in this chapter.

Configure the Novell Server (NetWare 3.X and 4.X)

This section covers setup for Novell NetWare Version 3.X and 4.X using PConsole.

1.Check the AUTOEXEC.NCF file on the Novell file server

from the server console. If the following statement is not in the file, add it using a text editor.

Set allow unencrypted passwords = on

2.Login to the network with supervisory privileges.

3.Type PCONSOLE and press Enter.

4.Set up the print server name using the following procedure. To use a print server name other than the default, see the previous section.

Note: The print server name on the printer must match the corresponding print server name on the Novell file server. For example use xante_ps for both of these names. It also is recommended that you name the Novell file server queue a similar name such as xante_q.

a.Select Available Options: Print Server Information

(version 3.X) or Available Options: Print Servers (version 4.X) and press Enter.

b.For version 4.X only, press the F4 key for bindery emulation (XANTÉ does not support NDS [NetWare Directory Services]).

c.Press Insert and type in your printer’s default PostScript

name adding _PS as an extension. This is the printer’s default Novell print server name that appears on the

start-up page.

_______________________________________ Ethernet Setup 5-7