Xante 3 Series warranty Turning the Printer Off

Printer initialization takes approximately 60 seconds. When READY/ IDLE displays, the printer is ready to accept print jobs.

Note: Due to movement during shipping, XANTÉ recommends that you calibrate your printer after setup. For procedures, see “Accurate Calibration Technology (X-ACT)” in chapter 3 (Macintosh) or 4 (PC).

Following initialization, a start-up page prints if that feature is enabled. This page lists the selected resolution, installed RAM, hard disk identities, page count, enabled interfaces, and network information. Review this page to be sure that the printer is properly configured. See “Start-up Page” in chapter 6 for details.

Turning the Printer Off

1.Verify that the READY/IDLE message displays.

2.Press the O on the power switch to turn off the printer (fig. 2.34).

Note: When the printer is turned off, job information in memory is lost.

◊ ◊ ◊

2-28 Installation _________________________________________