Xante 3 Series warranty Windows NT 4.X Configuration, Configure the Printer Setup on the Network

6.Choose File: Quit. Command Center closes.

7.Restart the printer to make the new TCP/IP address take effect.

Configure the Printer Setup on the Network

There are several UNIX operating systems, including System V (SYSV), Berkeley Standard Distribution (BSD), and Solaris. Each system handles line printer modes differently. Your System

Supervisor must configure the print queue, communications, and spool settings for your specific network environment.

Windows NT 4.X Configuration

Windows NT is a cross platform networking system. This section describes how to configure the printer’s Ethernet interface for TCP/IP or EtherTalk protocols on a system running Windows NT 4.X.

LPR Port Setup for TCP/IP

After completing the driver installation, use the following procedure to configure your printer for Windows NT 4.X network printing.

1.Make sure that the TCP/IP address has been setup on your printer for your network and that you can PING this address from your PC. If not, see “TCP/IP Addresses” and “Set the TCP/IP Address” earlier in this chapter for details and check with your System Administrator.

2.Click Start: Settings: Printers. Then, right click on the new XANTÉ icon and select Properties.

3.Click the Ports Tab; then, click Add Port. The Printer Ports window appears (fig. 5.23).

5-28 Ethernet Setup ______________________________________