Xante 3 Series Using Xanté Command Center Macintosh, Printer displays the READY/IDLE message

Note: The printer enters a waiting state while it saves the file server name. Do not proceed until the

printer displays the READY/IDLE message.

5.If a password is required to access the file server, change the print server password to agree with the password set up on the file server.

Note: If no password is required to access the Novell server, this step is not required.

a.Choose Controller: Novell: Set Print Server Password.

b.Type in the password exactly as it was entered on the file server. The password is case sensitive and must follow

the Novell NetWare naming conventions.

Note: The printer enters a waiting state while it saves the file server name. Do not proceed until the

printer displays the READY/IDLE message.

6.Repeat steps 2 through 5 to add up to four file servers.

7.Print a start-up page by taking the printer off line, pressing the

front panel Test button, and then putting the printer back on line. Check the page to be sure the new print server name is enabled.

8.Go to “Configure the Novell Print Server Interface” later in this chapter to continue configuration. To complete configuration

using printer front panel menus, rather than XANTÉ Command Center, choose File: Exit to close Command Center.

Using XANTÉ Command Center (Macintosh)

1.Open XANTÉ Command Center by double-clicking its icon.

2.Choose Networking: Novell Print Server: File Servers. Click Add New to open the new file server window.

_______________________________________ Ethernet Setup 5-17