Xante 3 Series warranty PC Setup

Note: This does not enable the Spooler on your printer.

The Spooler must be enabled using either the front panel Interface menus or XANTÉ Command

Center. See “Spooler” in chapter 6 and “Spooler” later in this chapter for details.

c.Select the amount of RAM installed on your printer. For Windows 95 and 98, use the VMOption and then go to step 4. For Windows NT 4.X, use Installable Options:InstalledMemory and then skip to step 8.

4.Click the Graphics tab and set the printer’s default resolution for the highest resolution available on your printer.

5.Click the Details tab and make the following changes for a local printer. These options are not available for a networked printer.

a.Under Timeout, make sure the settings are

•Not Selected: 300

•Transmission Retry: 900

b.Click Spool Setting and select the following options; then, click OK to close the Spool Settings Window.

•Spool data format: RAW

•Enable bidirectional support for this printer (selected)

6.Click the PostScript tab.

4-22 PC Setup __________________________________________