Xante 3 Series warranty Enable Menus, Mode Menus

SETUP:I/F

ENTER

TESTMENU

I/F:IP ADDRESS	I/F:RS232	I/F:PARALLEL
ENTER	ENTER	ENTER
192.009.200.201*	RS232:ENABLE	PARALLEL:ENABLE
	RS232:MODE	PARALLEL:HNDSHK
	RS232:BAUD RATE	PARALLEL:MODE
	RS232:PARITY	PARALLEL:SPOOL
	RS232:FLW CNTL
	RS232:DATA BITS
	RS232:STOP BITS
	RS232:SPOOL
*Default address

Fig. 6.11 Interface Menus

I/F:XXXX*

ENTER

XXXX* :ENABLE

XXXX* :MODE

XXXX* :SPOOL

*XXXX will be replaced by the selected interface (LTALK, ETALK, LPR, or NETBEUI

I/F:NVL PSRV

ENTER

NVL PSRV:ENABLE NVL PSRV:MODE NVL PSRV:PRTOCOL NVL PSRV:SPOOL NVL PSRV:TIMEOUT

Enable Menus

Use Enable menus to enable (Yes) or disable (No) each interface. The LocalTalk, RS232, and parallel interfaces are enabled as factory defaults. Factory defaults for the Ethernet interface are enabled for EtherTalk and LPR and disabled for Novell Print Server.

Mode Menus

Use Mode menus to select the printer mode for files sent across each interface. RS232 and parallel Mode menus allow you to select from the following options:

•PostScript Standard (PS STD)

•PostScript Binary (PS BIN)

•PostScript Tagged Binary Communication Protocol (PS TBCP),

•HPGL (HP-GL) emulation

•HP PCL5e (PCL5) emulation

•Automatic Interface Switching (AIS RAW)

•Automatic Interface Switching Binary (AIS BIN)

•Automatic Interface Switching Tagged Binary Communication Protocol (AIS TBCP).

The LocalTalk, EtherTalk, LPR, and Novell Print Server are set for the PostScript Standard (PS STD) printer mode. PS STD is the factory default for all interfaces except parallel, which is set to PS TBCP.

_______________________________________ Configuration 6-23