Xante 3 Series warranty Press the Menu key until

Note: To use the front panel XACT menu, you need a ruler with 1/2 millimeter rule. Also, you must use the paper cassette, not the multipurpose feeder, when making X-ACT adjustments. Adjustments for one size media apply to every media size, so you do not have to make individual adjustments for each size.

1.Make sure the printer is on and idle. Then, make sure that

media the size of your final output is loaded in the printer’s paper cassette and the cassette is selected as the media source.

2. Press the Menu key until		SETUP:MISC appears. Then, press
	the Enter key.
3.	Press the Menu key until	MISC:XACT appears. Then, press
	the Enter key.
4.	Press the Menu key until	XACT TEST PAGE appears. Then,

press the Enter key. A page prints with 2 lines, Line A and Line B. The measurement listed by each line is the desired length for that line on that media size. In this example, Tabloid size 11" x 17" (257 mm x 431 mm) media is used. Line A should be 251.46 mm and Line B should be 388.61 mm.

5.Measure Line A. Use the following procedures to adjust the printer for the correct line length.

a.Note the amount Line A is over or under 251.46 mm.

b.	Press the Menu key until	LINE A appears. Then, press
	the Enter key.

c.Press the Menu key until the amount which would most closely adjust the line to the desired length appears. Then, press the Enter key. For example, if Line A is 250.46 mm instead of 251.46 mm, select 1.00 mm to add one mm to make the line the correct length.

6.Measure Line B. Use the following procedures to adjust the

printer for the correct line length.

___________________________________________ PC Setup 4-45