Xante 3 Series warranty Command Center X-ACT

a.Note the amount Line B is over or under 388.61 mm.

b.	Press the Menu key until	LINE B appears. Then, press
	the Enter key.

c.Press the Menu key until the amount which would most closely adjust the line to the desired length appears.

Then, press the Enter key. For example, if Line B is 389 mm instead of 388.61 mm as it should be, select -0.50 mm to shorten the line to 388.50.

7.Press the Reset key to return to the previous menu level. Then, press the Menu key until XACT:TEST PAGE reappears and press the Enter key to print a new test page.

8.Repeat steps 5 and 6 until the line measurements agree with the lengths listed on the test page.

9.Press the On Line key when the line lengths are correct.

READY/IDLE appears in the window.

Now the printer’s line lengths are calibrated correctly.

Command Center X-ACT

Use XANTÉ Command Center’s X-ACT feature to calibrate printer

line lengths and correct inaccuracies in printing width, height, skew, and angle.

Note: You must have Command Center and your printer’s current PPD installed before you can use Command Center’s X- ACT. You also will need a 1/2 millimeter ruler.

1.Open XANTÉ Command Center and select Controller: More X-ACT. The More X-ACT window appears (fig. 4.28).

4-46 PC Setup __________________________________________