Xante 3 Series warranty AppleTalk Setup for EtherTalk

6.Select the General tab; then, click Print Test Page and check the printer to see if the Windows NT Test Page printed correctly.

7.Click OK. The Printer Properties window closes.

8.Select File: Close. The Printers window closes.

After installing and configuring the AdobePS printer driver and PPD, see “Configuring the Printer” in chapter 4 to verify that printer interfaces are configured properly.

AppleTalk Setup for EtherTalk

After completing the AdobePS driver installation, use the following procedure to configure your printer for Windows NT 4.X EtherTalk printing.

1.Click Start: Settings: Printers. Then, right click on the new XANTÉ icon and select Properties.

2.Click the Ports Tab; then, click Add Port. The Printer Ports window appears (fig. 5.23).

3.Select AppleTalk Printing Devices; then, click New Port. A window appears listing zone names if you have several AppleTalk zones on your network. If no zone names appear, skip to step 5.

Note: If AppleTalk Printing Devices is not an option, you must log in as the Administrator and select Control Panel: Network: Services and make sure that Microsoft TCP/IP Printing is installed. If not, click Add and select this feature. Then, restart your PC and AppleTalk Printing Devices will appear as an option for this procedure. (You may need the Microsoft NT CD to load this service.)

4.Click on the desired zone name. A window appears listing printers in that zone.

5-30 Ethernet Setup ______________________________________