10.Repack the 2,000 sheet feeder in the original box and store it in a location that meets the guidelines in “Printer Location” in chapter 2.

11.Set the printer up again following the instructions in chapter 2.

Duplexer

This section describes installing and removing the optional duplexer. The duplexer is used to create double-sided copy automatically and to separate print jobs with an offset. See “Duplexer” and “Print Job Offset Feature” in chapter 6 and “Optional Duplexer” in chapter 7.

Note: The optional duplexer is available only for 20 ppm printers. It cannot be used on printers with the 2400 dpi or NEIT upgrade installed.

Installing the Duplexer

Warning: The fuser becomes very hot during operation. To avoid burns, turn the printer off and allow it to cool for at least 40 minutes before touching any area with a high-temperature warning label (fig. 10.19).

CAUTION

VORSICHT

ATTENTION

0

HIGH TEMPERATURE

HEIZUNGSROLLEN SEHR HEISS

TEMPERATURE ELEVEE

 

ADVERTENCIA

CUIDADO

 

 

TEMPERATURA ELEVADA

ALTA TEMPERATURA

 

40

Fig. 10.19 High-Temperature Warning on the Fuser

___________________________________________ Options 10-19

Page 267
Image 267
Xante 3 Series warranty Installing the Duplexer, High-Temperature Warning on the Fuser