4.Clean toner from the transfer roller with a soft bristle brush.

5.Vacuum the area using a soft brush attachment or blow it with compressed air.

Warning! Wear protective safety glasses when using compressed air.

Caution: Do not pull out wires while performing this step.

6.Lower the roller back into place with the gear end to the left. Make sure the lever protruding below the transfer roller fits inside the small opening on the door.

7.Push the roller into its holding clips. The roller assembly should spring back freely when pressed.

Toner and Manual Feed Area Cleaning

Clean the toner and manual feed area after removing a paper jam or replacing the toner cartridge.

1.Turn off the printer and disconnect it from the power source; then remove the paper jam or the toner cartridge.

Caution: The fuser becomes very hot during operation. Always allow the fuser to cool completely before opening the fuser cover. If a paper jam occurs in the fuser area, turn off the printer and wait at least 30 minutes before attempting to clear the jam.

2.Remove any paper scraps and wipe off paper and toner dust with a dry clean cloth (fig. 9.3).

9-8 Maintenance and Specifications ________________________

Page 242
Image 242
Xante 3 Series warranty Toner and Manual Feed Area Cleaning