b.Push the SIMM or SODIMM into its bank using the following appropriate step.

1)Flash ROM or FIFO SIMM—tilt the SIMM up in its bank until it is positioned at a 90° angle with the controller board making sure the bank latch snaps into place (fig. 10.34).

2)SODIMM—push the SODDIM straight down into its bank until the bank latch snaps into place.

Caution: Do not force a SIMM or SODIMM into place. If it does not go in easily, realign it making sure that the notched corner is positioned correctly and that the SIMM or SODIMM is seated correctly in its bank.

Notch

45˚

Gently Rotate the Simm

Into a 90˚ Position, Until

the Two Latches Catch

Fig. 10.34 Installing a SIMM

Replacing the Controller Board Panel

After installing the upgrade(s), replace the controller board panel.

1.Insert the tab on the top of the controller board panel into the slot above the opening (fig. 10.29).

10-32 Options __________________________________________

Page 280
Image 280
Xante 3 Series warranty Replacing the Controller Board Panel, Installing a Simm