Printer Timeout

The Timeout feature allows you to select the number of seconds the printer waits for additional data before cancelling a job and returning to the READY/IDLE state.

Set Timeout from the MISC:TIMEOUT configuration menu. The factory default of 40 seconds (40 Sec) is an average setting. Set timeout according to the type of files you send. Use a low setting for small, simple files to prevent an indefinite tie-up on one job. Use the 300 or Never setting for large files, such as graphic intensive or CAD (Computer Aided Design) files, to allow enough processing time.

With the NEVER selection, the printer does not timeout; it waits until it receives additional data or until the printer is reset.

RAM Disk

RAM Disk allows you to set aside a section of printer RAM to be used as a read/write device for implementing XANTÉ’s Font Accelerator.

Set RAM Disk from the MISC:RAM DISK configuration menu. 0, the factory default, disables RAM disk. Options are in 1 MB increments to the maximum available RAM, which is the installed RAM minus 32 MB (the base amount of RAM required by the system). The printer must be restarted for the RAM disk setting to become active.

Resolution Options

The standard configuration is 600 x 600 dpi for the Accel-a-Writer 3N and 3DN with a 1200 x 1200 upgrade available. The 3G has standard 600 x 600 and 1200 x 1200 dpi resolutions, which print at 20 page per minute for letter/A4 size paper. The optional 2400 x 2400 upgrade for the 3G includes all standard Accel-a-Writer 3G features and provides 10 page per minute printing of letter/A4 size paper at all three resolutions.

6-34 Configuration

______________________________________

Page 208
Image 208
Xante 3 Series warranty Printer Timeout, RAM Disk, Resolution Options