Patton electronic SmartNode 4110 Series manual Figuration mode

SmartWare Software Configuration Guide 36 • FXO interface configuration

Mode: Interface FXO

Step	Prompt, command & response	Purpose
1	node>	Basic prompt in Operator
		Exec mode
2	node>enable	Enters Administration execu-
		tion mode
	node#	Response: The prompt in
		administration execution
		mode is the #
3	node#configure	Enters the Configure configu-
		ration mode
	node(cfg)#	Response: The prompt in the
		Configure configuration
		mode is (cfg)#
4	node(cfg)#context cs	Enters the Context CS config-
		ure mode
	node(ctx-cs)[switch]#	Response: The prompt in the
		Context CS configuration
		mode is (ctx-cs)[switch]#
5	node(ctx-cs)[switch]#interface fxo if-name	Enter the Interface FXO con-
		figuration mode
	node(if-fxo)[if-name]#	Response: The prompt in the
		Interface FXO configuration
		mode is (if-fxo)[if-name]#
6	node(if-fxo)[if-name]#dial-after {dial-tone timeout seconds}	Specifies whether to dial
		after detection of dial-tone
		(default) or to wait for a
		specified timeout (in sec-
		onds). Zero (0) seconds will
		initiate dialing immediately
		after going off-hook.

Example: Setting the timeout to be 4 seconds after going off-hook when initiating a call. The timeout is set for the FXO interface named Line0.

node>enable

node#configure node(cfg)#context cs node(ctx-cs)[switch]#interface fxo Line0 node(if-fxo)[Line0]#dial-after timeout 4

You can verify the change in configuration by using the show running-configcommand.

This is one of the few commands that does not have a no inverse operation of the command. If you want to change the timeout period, re-enter the command with the new timeout period. The other option is to wait for dial-tone. To return to the default (waiting for dial-tone before dialing), enter the command again using dial-tone.

FXO interface configuration task list 420