Patton electronic SmartNode 4110 Series manual Configuring when the digits are dialed optional

SmartWare Software Configuration Guide36 • FXO interface configuration

Mode: Interface FXO

	Step	Prompt, command & response	Purpose
1	node>	Basic prompt in Operator Exec mode
2	node>enable	Enters Administration execution mode
		node#	Response: The prompt in administration execu-
			tion mode is the #
3	node#configure	Enters the Configure configuration mode
		node(cfg)#	Response: The prompt in the Configure configu-
			ration mode is (cfg)#
4	node(cfg)#context cs	Enters the Context CS configure mode
		node(ctx-cs)[switch]#	Response: The prompt in the Context CS configu-
			ration mode is (ctx-cs)[switch]#
5	node(ctx-cs)[switch]#interface fxo if-name	Enter the Interface FXO configuration mode
		node(if-fxo)[if-name]#	Response: The prompt in the Interface FXO con-
			figuration mode is (if-fxo)[if-name]#
Now we can apply the PSTN profile for the FXO interface named name as follows.
	Step	Prompt, command & response		Purpose

6node(if-fxo)[if-name]#[no] use profile pstn profile-name The “profile pstn” command is applied to the FXO interface named if-name

node(if-fxo)[if-name]#	Response: You are now in the
	FXO interface configuration
	mode. In this mode, you may con-
	figure the parameters for the FXO
	interface name.

Configuring when the digits are dialed (optional)

When the FXO port goes off-hook to make an outgoing call, the FXS switch normally sends a dial-tone to indicate it is ready to received dialed digits. Alternatively, you can specify the FXO interface to wait a specific period of time after going off-hook before dialing the first digit.

Note All countries do not have the same dial-tone. For information on configur- ing the dial-tone for your country, refer to chapter 42, “Tone configuration” on page 529.

The default setting is to wait for the dial-tone. If you choose to wait a specific time after going off-hook, the variable is timeout and specify the number of seconds to wait. Zero (0) seconds means that the interface dials immediately.

FXO interface configuration task list 419