Patton electronic SmartNode 4110 Series manual Mode Interface FXS, Nameif-fxsname#no subscriber

SmartWare Software Configuration Guide 35 • FXS interface configuration

Mode: Interface FXS

Step	Command	Purpose
1	[name](if-fxs)[name]#[no] subscriber-	Applies a subscriber number for the fxs interface.
	number <number>	The no form of the command clears an existing one.
		Default: none

Configuring an alternate PSTN profile (optional)

The PSTN profile contains the configuration for data/voice transmission on circuit-switched channels (See chapter 48, “PSTN profile configuration” on page 597). In the case of FXS interfaces, the PSTN profile applies to the analog line associated with the interface. There is a PSTN profile named default, which always exists in the system. If no different PSTN profile name is explicitly configured on the FXS interface, the profile named default is used.

Mode: Interface FXS

Step Command Purpose

1[name](if-fxs)[name]#use profile pstn Defines an alternate PSTN profile to be used for this

profile-name FXS interface.

Configuring caller-ID presentation (optional)

FXS/FXO protocols allow the presentation of the caller-ID (calling party number and name of an incoming call) to an analog terminal when the terminal is ringing. (See Chapter 43, “FXS port configuration” on page 537 for other caller-ID related settings.) Use this command to configure presentation of the calling party number to the analog device connected to the FXS port associated with the interface.

Mode: Interface FXS

Step	Command	Purpose
1	[name](if-fxs)[name]#[no] caller-id-pre-	Enables/Disables the caller-id presentation and
	sentation {pre-ring mid-ring}	defines if it must be sent before ring starts or in the
		first ring pause.

Configuring flash hook processing (optional)

The flash-hookcommand specifies if the flash hook pattern must be handled locally or if it must be relayed to the remote subscriber. Per default flash hook is handled locally because it is the initial pattern for local initiated supplementary services. If the flash hook is relayed to the remote subscriber, the local user will not be able to initiate a second call. The relay feature is used if the termination instance of the remote protocol is configured to handle all the supplementary services.

Mode: Interface FXS

Step	Command	Purpose
1	[name](if-fxs)[name]#flash-hook {han-	Defines processing instance of the flash hook pat-
	dle-locally relay}	tern.
		Default: handle-locally

FXS interface configuration task list 406