Patton electronic SmartNode 4110 Series manual Call reroute, Mode context cs/interface sip

SmartWare Software Configuration Guide 40 • Call router configuration

Call reroute

The call-reroutecommands enable acceptation and emission of rerouting requests.

Enable acceptation of rerouting requests on ISDN. If a reroute is accepted, the participant who sends the reroute request is disconnected and the call is established from the SmartNode to the new destination.

Mode: context cs/interface isdn

Step Command Purpose

1[name](if-isdn)[interface]#[no] call- Enables acceptation of rerouting requests from ISDN.

reroute accept Default is disabled.

Enable emission of rerouting requests on ISDN. To reroute a call must enter and leave SmartNode through the same ISDN interface and every service invoked must allow push-back.

Mode: context cs/interface isdn

Step Command Purpose

1[name](if-isdn)[interface]#[no] call- Enables emission of rerouting requests from ISDN.

reroute emit Default is disabled.

Enable sending of “302 moved temporary” message on SIP. To reroute a call must enter and leave Smart- Node through the same SIP gateway and every service invoked must allow push-back.

Mode: context cs/interface sip

Step Command Purpose

1[name](if-sip)[interface]#[no] call- Enables emission of “302 moved temporarily” message on

reroute emit SIP. Default is disabled.

Allow Push-Back

The push-backcommand allows or forbids rerouting of a call, if the service is invoked.

Enable push-back – aaa service.

Mode: context cs/service aaa

Step	Command	Purpose
1	[name](svc-aaa)[service]#[no]	Enables push-back of a call of this service.
	allows-push-back	Default is disabled.

Call router configuration task list 522