Patton electronic SmartNode 4110 Series manual Test the call router configuration

SmartWare Software Configuration Guide 40 • Call router configuration

Procedure: To show and activate the call router configuration

Mode: Context CS

Step	Command	Purpose
1	node(ctx-cs)[switch]#show call-router	Show the actual call router configuration. This displays all
	config	routing and mapping tables in the current context CS. When
		you are inside a routing or mapping table configuration
		mode, only the current table is displayed.
2	node(ctx-cs)[switch]#show running-	Show the whole running config includes the call routing
	config	tables
3	node(ctx-cs)[switch]#debug call-	Enable the call router debug monitor. Use level 1 for get
	router detail level	informed about errors and increase the level up to 5 to track
		calls during route lookups.
4	node(ctx-cs)[switch]#no shutdown	Activate the whole CS context configuration including the call
		router configuration.
5	node(ctx-cs)[switch]#show call-router	Show the actual call router status. This command can be used
	status	to examine whether or not the call router accepted all routing
		entries as entered in the configuration.

Note Unlike previous versions of SmartWare you must explicitly enter the no shutdown command to activate the call router.

Test the call router configuration

After activating the call router configuration you can test the call router by simulating a route lookup as if a call is routed to a table. You have to execute the test call-router command and specify all necessary call properties together with the routing table you want to test.

Note You must activate the call router using the no shutdown command first.

Procedure: To test the call router configuration

Mode: Context CS

Step	Command	Purpose
1	node(ctx-cs)[switch]#debug call-	Enables the call router debug monitor. Chose level 5 to trace
	router detail level	route lookups in detail.
2	node(ctx-cs)[switch]#test call-router	Tests the routing or mapping table table-namewith the speci-
	table-name [property-type property-	fied call property. You can repeat the optional section multi-
	value]	ple times and thus enter as many call properties as you want.

Example: Create and test a routing table

node(cfg)#context cs node(cts-cs)[switch]#routing-table called-e164 TEST node(rt-tab)[TEST]#route 1 dest-interface IF1 node(rt-tab)[TEST]#route 1[0-4] dest-interface IF2 node(rt-tab)[TEST]#route 11 dest-interface IF3 node(rt-tab)[TEST]#route 111T dest-interface IF4

Call router configuration task list 515