Patton electronic SmartNode 4110 Series manual Binding the interface to an H.323 gateway

SmartWare Software Configuration Guide 38 • H.323 interface configuration

•Configuring information transfer capability handling (optional)

•Configuring CLIP/CLIR support (optional)

•Enabling the early-proceeding feature for call setup

•Enabling the early call disconnect (optional)

•Enabling the via address support (optional)

•Overriding the default destination call-signaling port (optional)

•Configuring status inquiry settings (optional)

Binding the interface to an H.323 gateway

Every H.323 interface must be explicitly bound to an H.323 gateway instance.

Procedure: To bind an H.323 interface to an H.323 gateway.

Mode: Interface H.323

Step

1

Command	Purpose
node(if-h323)[if-name]#bind gateway	Binds the gateway to an H.323 gateway.
gw-name

Examples: Bind the H.323 interfaces to an H.323 gateway instance

The following example shows how to bind an H.323 interface named MyH323If to an H.323 gateway instance named h323.

node>enable

node#configure node(cfg)#context cs

node(ctx-cs)[switch]#interface h323 MyH323If node(if-h323)[MyH323If]#bind gateway h323 Configure a remote IP address

If the gateway to which the H.323 interface is bound does not use a gatekeeper, it is required to specify the IP address of the remote entity for which the H.323 interface is used directly within the H.323 interface. This is done using the procedure below. If the H.323 gateway however uses a gatekeeper, the gatekeeper is responsible for resolving the remote entities IP address. In that case this procedure must not be used.

Procedure: To specify the remote H.323 entities IP address in the H.323 interface.

Mode: Interface H.323

Step

1

Command	Purpose
node(if-h323)[if-name]#remoteip ip-	Defines the IP address of the remote H.323
address	entity, for which this interface shall be used.

Examples: Define the IP address of the remote H.323 entity

H.323 interface configuration task list 433