Patton electronic SmartNode 4110 Series manual Ending a Telnet or console port session

SmartWare Software Configuration Guide 4 • Accessing the CLI

Ending a Telnet or console port session

Use the logout command in the operator or administration execution mode to end a Telnet or console port ses- sion. To confirm the logout command, you must enter yes on the dialog line as shown in the example below.

Mode: Operator execution

Step	Command	Purpose
1	node>logout	Terminates the session after a confirmation by the user.

Example: End a Telnet or console port session

The following example shows how to terminate a session from the administrator execution configuration mode.

node>logout

Press 'yes' to logout, 'no' to cancel :

After confirming the dialog with “yes”, the Telnet session is terminated.

Note Using the command exit in the operator execution mode also terminates a

Telnet or console port session, but without any confirmation dialog.

Showing command default values

If a command is set to its default value, it is not displayed in the running-config in order to make it more read- able. There are a few exceptions to this rule. The command cli config defaults makes commands also appearin the running-config that are set to default values. no li config defaults turns it off.

Accessing the SmartWare CLI task list 64