Patton electronic SmartNode 4110 Series manual 11 NAT/NAPT configuration

SmartWare Software Configuration Guide Table of Contents

Debug ARP	129
Traceroute	130
Configuring the IGMP Proxy	131
11 NAT/NAPT configuration	132
Introduction	133
Dynamic NAPT	133
Static NAPT	134
Dynamic NAT	134
Static NAT	135
NAPT traversal	135
NAT/NAPT configuration task list	136
Creating a NAPT profile	136
Configuring a NAPT DMZ host	137
Defining NAPT port ranges	137
Preserving TCP/UDP port numbers in NAPT	138
Defining the UDP NAPT type	138
Activate NAT/NAPT	139
Displaying NAT/NAPT configuration information	139
Configuring NAT static protocol entries	140
12 Ethernet port configuration	141
Introduction	142
Ethernet port configuration task list	142
Entering the Ethernet port configuration mode	142
Configuring medium for an Ethernet port	142
Configuring Ethernet encapsulation type for an Ethernet port	143
Binding an Ethernet port to an IP interface	143
Multiple IP addresses on Ethernet ports	144
Configuring a VLAN	145
Configuring layer 2 CoS to service-class mapping for an Ethernet port	146
Adding a receive mapping table entry	147
Adding a transmit mapping table entry	148
Closing an Ethernet port	148
Using the built-in Ethernet sniffer	149
13 Link scheduler configuration	151
Introduction	152
Applying scheduling at the bottleneck	152
Using traffic classes	152
Introduction to Scheduling	153
Priority	153
Weighted fair queuing (WFQ)	153
Shaping	153
Burst tolerant shaping or wfq	154
Hierarchy	154
	9