Patton electronic SmartNode 4110 Series manual Frequency-shift keying, Mat etsi, Mat bell

SmartWare Software Configuration Guide 35 • FXS interface configuration

Frequency-shift keying

Frequency-shift keying signaling can be specified in FXS port configuration mode, in one of the following for- mats:

1.Multiple Data Message Format (MDMF) (etsi standard) (default).

2.Single Data Message Format (SDMF) (bell standard).

To enable frequency-shift keying by MDMF standard, use the existing caller-id format command.

Note MDMF(etsi) is a default value and it will not be visible in “show running- config” output.

Step Command Purpose

1[node](prt-fxs)[num/num]#caller-id for- Selects MDMF standard for sending frequency-shift

mat etsi keyed messages

To enable frequency-shift keying by SDMF standard, use existing caller-id format command (please note that as of May 21st, 2008 there were no confirmed test results about SDMF frequency-shift keying signaling func- tioning properly):

Step Command Purpose

1[node](prt-fxs)[num/num]#caller-id for- Selects SDMF standard for sending frequency-shift

mat bell keyed messages

Note The tone cadence for stutter dial tone can be set in profile tone-setmode. The tone type name for a tone that should represent a waiting message is message-waiting-toneand by default it is set to defaultStuttertone (on,100,425,-7,off,100). Refer to Chapter 42, “Tone configuration” on page 529 for information on setting up tone profiles.

FXS interface configuration task list 409