Patton electronic SmartNode 4110 Series manual Create a dialer, Create outbound destinations

SmartWare Software Configuration Guide 30 • PPP configuration

•Retry List: A list of up to 8 retry timeouts that define if and when a retry is started for the same destination after a failed dial attempt.

•Binding: By binding a dialer destination to a PPP subscriber configuration entity, you define the PPP pro- tocol parameters (e.g. multi-link) and credentials that are applied to the dial-up connection. Note that each dialer destination (link to a dial-up provider) may define its own credentials and PPP parameters. The PPP subscriber configuration entity also defines from which IP interface the dial-trigger is received.

•PPP Profile: A PPP profile can be used to fine-tune PPP protocol parameters.

Create a dialer

The following command creates a new PPP dialer.

Mode: context cs

Step	Command	Purpose
1	[name] (ctx-cs)[router]# interface dialer	Creates a new dialer and enters its configura-
	<dialer-name>	tion mode.

Create outbound destinations

Follow the steps below to create an outbound destination instance. Each destination contains all information needed to dial and log into a certain remote-access server (i.e. remote party number, login credentials, PPP parameters, ect.). You can create more than one destination in order to fall back to another provider if the first provider is not accessible at the moment.

Mode: context cs/interface dialer

Step	Command	Purpose
1	[name] (if-dialer)[dialer]#outbound	Creates an outbound destination where all
	PROVIDER1	dial-up and login information for a certain
		provider can be configured.
2	[name] (outbound)[provider]#local-e164	Configures the calling-party number that shall
	<e164>	be used to establish the call. This is the num-
		ber of the local system.
3	[name] (outbound)[provider]#remote-e164	Configures the called-party number that shall
	<e164>	be used to establish the call. This is the num-
		ber of the remote access server.
4	[name] (outbound)[provider]#route call	Specifies a destination interface for call estab-
	dest-interface <if-name>	lishment (basic interface routing) or a destina-
	[name] (outbound)[provider]#route call	tion table or call service (advanced call
		routing).
	dest-table <table-name>	See Chapter 33, “CS interface configuration”
	[name] (outbound)[provider]#route call	on page 381 for further information.
	dest-service <if-name>

PPP Dial-up over ISDN 332