Patton electronic SmartNode 4110 Series Default setting is, Detail debug-level, Signaling message

SmartWare Software Configuration Guide45 • H.323 gateway configuration

Step	Command	Purpose
7	node(gw-h323)[h323]#h235-security ras-	Enables or disables H.235 security for trans-
	auth-int-tx [<msg>]	mitted RAS packets. msg is the message type.
	or
	node(gw-h323)[h323]#no h235-security
	ras-auth-int-tx [<msg>]
8	node(gw-h323)[h323]#h235-security q931-	Enables or disables H.235 security for call-
	auth-int	signaling.
	or
	node(gw-h323)[h323]#noh235-security
	q931-auth-int
9	node(gw-h323)[h323]#h235security	If all parameters are set, enables H.235 secu-
		rity. Otherwise returns an error message.
10	node(gw-h323)[h323]#show h235security	Shows status of H.235 security module.
11	node(gw-h323)[h323]#debug h235security	Enables the H.235 debug monitor to display
	[detail debug-level]	information for every received and sent H.323
		signaling message.

For example to disable signature verification of RCF messages enter the command no h235-security ras- auth-int-rx rcf. When not specifying the message type, you change the behavior of all message types. Addi- tionally there are special message-types that manipulate the behavior of message-groups:

'request' ==> ARQ, BRQ, DRQ, GRQ, IRQ, LRQ, RAI, RRQ, SCI, URQ

'response' ==> ACF, BCF, DCF, GCF, IACK, IRR, LCF, RAC, RCF, RIP, SCR, UCF 'reject' ==> ARJ, BRJ, DRJ, GRJ, INAK, LRJ, RRJ, URJ

E.g. 'no h235-security ras-auth-int-rx reject' disables verification of the H.235 signature of all received reject messages, e.g. GRJ, RRJ, ARJ.

The default setting is:

h235-security ras-auth-int-rx request h235-security ras-auth-int-rx response no h235-security ras-auth-int-rx reject h235-security ras-auth-int-tx request h235-security ras-auth-int-tx response no h235-security ras-auth-int-tx reject

The command show h235-securityshows the current setting.

Gateway configuration task list 553