Patton electronic SmartNode 4110 Series Nodecfg #show ppp links level, Nodecfg #show pppoe name

SmartWare Software Configuration Guide30 • PPP configuration

Mode: Configure

Step	Command		Purpose
1	node(cfg) #show ppp links [ level ]		Displays status and configuration information of
			the Link Control Protocol (LCP) and the authentica-
			tion protocol(s) (PAP and/or CHAP). Check
			whether the states of the two protocols are
			‘Opened’.
			level specifies to level of details displayed (1..4,
			default is 1).
2	node(cfg) #show ppp networks [ level ]		Displays status and configuration information of
			the Network Control Protocol(s) (NCP), in particu-
			lar the IP Control Protocol (IPCP). Check whether
			the states of this protocol is ‘Opened’.
			Under ‘Local configuration options’, you find the IP
			address proposed by this SmartNode and under
			‘Local acknowledged options’, the IP address
			assigned by the remote peer.
			level specifies to level of details displayed (1..4,
			default is 1).
3	node(cfg) #show pppoe [ name ]		Displays status, configuration information, and sta-
			tistics of PPPoE in general and of the PPPoE ses-
			sion(s). Check whether state of the respective
			session is ‘Opened’.
			level specifies to level of details displayed (1..4,
			default is 1).
4	node(cfg) #show port interface name		Displays status and configuration information of the
			IP interface at which a PPP connection terminates.
			Check whether state of the interface is ‘OPENED’.
			Under ‘Local IP Address’, you find the IP address
			assigned to the IP interface. If it does not corre-
			spond to the IP address assigned by the PPP
			remote peer, check whether the ‘ipaddress’ of the
			IP interface is set to ‘unnumbered’.
5	node(cfg) #show port ethernet slot port		Displays status and configuration information of the
			Ethernet/serial port over which a PPP connection/
			PPPoE sessions runs. Check whether state of the port
			is ‘OPENED’ and whether the encapsulation is set to
			‘pppoe’ or ‘multi’ (only for Ethernet ports).
6	node(cfg) # [no] debug ppp [ all ... ]		Enables all or a particular PPP debug monitor.
7	node(cfg) # [no] debug pppoe [ all ...	]	Enables all or a particular PPPoE debug monitor.

PPP configuration task list 326