Patton electronic SmartNode 4110 Series Troubleshooting DSL Connections, Diagnostics, Link State

SmartWare Software Configuration Guide21 • DSL Port Configuration

Diagnostics

Table 11. Diagnostics commans

	Command	Purpose
Step 1	node> show dsl type	Displays the type of modem installed.
Step 2	node> show dsl line-state	Displays information about the state of the DSL
		link.
Step 3	node> show dsl version	Display firmware version information for the
		modem.
Step 4	node# debug dsl-setup	Lists the configuration interactions between the
		gateway and the modem module.

Troubleshooting DSL Connections

Link State:

•Verify that the DSL link is established (status LED is continuously on)

PPPoE access:

•Check if "show pppoe detail 3" shows "State: .... opened". This indicates that the PVC is valid and a that you reached a PPPoE server through it.

•Check if "show ppp networks detail 3" shows "State: .... opened" for both the "LCP" and the "CHAP" sec- tion. If LCP is not working, there is probably no compatible authentication protocol configured. Make sure "authentication chap" and "authentication pap" are included in the subscriber setup. If only CHAP failed there may be an error with the username or password.

•Run the “debug” command: node# debug dsl-setup(See table 11 above).

Troubleshooting DSL Connections 234