Patton electronic SmartNode 4110 Series manual Interworking

SmartWare Software Configuration Guide 40 • Call router configuration

Table 21. Hunt group drop causes (Continued)

		Default Behavior
Class	Cause	of the Hunt	Description
		Group Service
Protocol Error	ie-does-not-exist	Drop original call	The remote equipment receives a message
(Cont.)			that includes information elements or call
			properties that are not recognized.
	invalid-ie-contents	Drop original call	The remote equipment receives a message
			that includes invalid information in the
			information element or call property.
	recovery-on-timer-	Drop original call	Your call was not completed, probably
	expiry		because an error occurred.
	protocol-error	Drop original call	An unspecified protocol error with no
			other standard cause occurred.
Interworking	interworking	Drop original call	An event occurs, but the network does not
			provide causes for the action it takes. The
			precise problem is unknown.

Example: Create a hunt group service

This example shows how to configure the hunt group service as shown in figure 66 on page 498.

node(cfg)#context cs node(ctx-cs)[switch]#service hunt-group HUNT-BRI node(func)[HUNT-BRI]#cyclic node(func)[HUNT-BRI]#timeout 6 node(func)[HUNT-BRI]#route dest-interface IF-BRI0 node(func)[HUNT-BRI]#route dest-interface IF-BRI1 node(func)[HUNT-BRI]#route dest-interface IF-BRI2 node(func)[HUNT-BRI]#route dest-interface IF-BRI3

Call router configuration task list 505