Patton electronic SmartNode 4110 Series manual Configuring an alternate VoIP profile optional

SmartWare Software Configuration Guide 38 • H.323 interface configuration

The following example shows how to associate an H.323 interface named MyH323If with a remote H.323 entity, which has the IP address 1.2.3.4

node>enable

node#configure node(cfg)#context cs

node(ctx-cs)[switch]#interface h323 MyH323If node(if-h323)[myh323if]#remoteip 1.2.3.4

Configuring an alternate VoIP profile (optional)

Normally, the VoIP profile defined in the H.323 gateway is used for all the calls over that gateway. However, it is possible to specify an alternate VoIP profile in the H.323 interface. In that case the VoIP profile defined within the VoIP interface is used for all the calls established using that H.323 interface instead of the VoIP pro- file defined in the H.323 gateway.

Procedure: To define an alternate VoIP profile for the H.323 interface

Mode: Interface H.323

Step

1

Command	Purpose
node(if-h323)[if-name]#use profile voip	Defines an alternate VoIP profile to be used
profile-name	for this VoIP interface

Example: Configure an alternate VoIP profile

The following example shows how to replace the default VoIP profile of the H.323 gateway with a VoIP profile named myprofile for an H.323 interface named MyH323If.

node>enable

node#configure node(cfg)#context cs

node(ctx-cs)[switch]#interface h323 MyH323If node(if-h323)[MyH323If]#use profile voip myprofile Configure information transfer capability handling (Optional)

Normally, the H.323 gateway transparently forwards the information transfer capability information element between the H.323 network and other gateways of the SmartNode. There are, however, several H.323 clients that do not provide correct information transfer capability information. One of the most often used clients of this type is Microsoft Netmeeting. When communicating to one of these clients, it is necessary to define the correct information transfer capability in the H.323 interface. It is possible to define for each direction (for calls from or to H.323) separately, whether the information transfer capability received from the network, or another information transfer capability should be used for the calls.

Note The default behavior when not configured otherwise is to set the informa- tion transfer capability of incoming calls to 3k1-audio and to transparently pass the information transfer capability for outgoing calls.

Procedure: To configure information transfer capability overriding

H.323 interface configuration task list 434