Patton electronic SmartNode 4110 Series manual Configuring a Vlan

SmartWare Software Configuration Guide12 • Ethernet port configuration

Mode: Configure

Step	Command	Purpose
1	[name] (cfg)# context ip	Enter the IP context configuration
		mode.
2	[name] (ctx-ip)[router]# interface <ip-if-1-name>	Create the first IP interface.
3	[name] (if-ip)[ <ip-if-1-name>]# ipaddress <ip-	Set the IP address for the first IP inter-
	address-1> <subnet-mask-1>	face
4	[name] (if-ip)[<ip-if-1-name>]# interface <ip-if-2-name>	Create the second IP interface.
5	[name] (if-ip)[<ip-if-2-name>]# ipaddress <ip-address-2>	Set the IP address for the second IP
	<subnet-mask-2>	interface
6	[name] (if-ip)[ <ip-if-2-name>]# port ethernet <slot>	Enter Ethernet port configuration
	<port>	mode
7	[name] (prt-eth)[<slot>/<port>]# encapsulation ip	Set the encapsulation to IP
8	[name] (prt-eth)[<slot>/<port>]# bind interface <ip-if-	Bind the port to the first IP interface
	1-name>
9	[name] (prt-eth)[<slot>/<port>]# bind interface <ip-if-	Bind the port to the second IP inter-
	2-name>	face
10	[name] (prt-eth)[<slot>/<port>]# no shutdown	Enable the Ethernet port

Configuring a VLAN

By default no VLAN ports are configured on an Ethernet port. One or more VLAN ports can be created on each Ethernet port.

You must bind the VLAN port to an existing IP interface. When executing the bind command, the requested interface must exist.

For incoming VLAN packets each of the 8 possible layer 2 class of services (CoS) can be mapped to a traffic class. Unless otherwise specified all CoS values map to the default traffic class.

By default all VLAN ports are initially disabled. They can be enabled with the no shutdown command. The corresponding Ethernet port must also be enabled for the VLAN port to work. If the Ethernet port is disabled, all associated VLAN ports are also disabled.

When a VLAN port is closed, the IP interface that is bound to this port is also closed. All static routing entries that are using this interface change their state to invalid and all dynamic routing entries will be removed from the route table manager.

Ethernet port configuration task list 145