Patton electronic SmartNode 4110 Series manual Configuring the baudrate, Baudrate

SmartWare Software Configuration Guide 14 • Serial port configuration

Example: Configuring the active clock edge

The following example enables to send data on the negative edge on slot 0 and port 0. Check that Transmit Clock is set to inverted in the command output of show port serial.

node(cfg)#port serial 0 0 node(prt-ser)[0/0]#transmit-data-on-edge negative node(prt-ser)[0/0]#show port serial

Serial Interface Configuration

------------------------------

Port	:	serial 0 0 0
State	:	CLOSED
Hardware Port	:	X.21
Transmit Edge	:	inverted
Port Type	:	DTE
CRC Type	:	CRC-16
Max Frame Length:		2048
Recv Threshold	:	1
Encapsulation	:	framerelay

Configuring the baudrate

A DCE interface has to provide the signal clocks. The desired baudrate can be configured.

Note Only available on certain devices.

This procedure describes how to set the baudrate for the serial interface.

Mode: Port serial

Step	Command	Purpose
1	node(prt-ser)[slot/port]# baudrate	Configures the baudrate for the serial interface.
	baudrate

Example: Configuring baudrate to 64,000 bps

The following example configures a baudrate of 64,000 bps on the serial interface. Verify that the command show port serial detail 5 output displays the correct baudrate. True baudrate in the Status section shows the baudrate of the selected hardware.

node(cfg)#port serial 0 0 node(prt-ser)[0/0]#transmit-data-on-edge negative node(prt-ser)[0/0]#show port serial detail 5

HDLC Driver: 0x8496b8

=====================

Slot:	0
Number of Ports:	1
Port: serial 0 0	0
------------------

Serial port configuration task list 175