SmartWare Software Configuration Guide

44 • FXO port configuration

 

 

Introduction

This chapter provides an overview of POTS signaling and SmartNode FXO ports and describes the tasks involved in configuring FXO ports in SmartWare.

This chapter includes the following sections:

Shutdown and enable FXO ports (see page 543)

Bind FXO ports to higher layer protocols (see page 544)

Configure country specific FXO port parameters (see page 544)

Configure other FXO port parameters (see page 544)

FXO stands for foreign exchange office and is the subscriber side of a POTS (plain old telephone system) line. An FXO port on the SmartNode simulates thus an analog phone set, which must actively go on-hook and off- hook, detect ringing and caller-id, and dial the called-party number using DTMF keypad.

Shutdown and enable FXO ports

FXO ports are enabled by default. They also can be configured when they are active. But keep in mind that configuration of an active port temporarily disables the port for a short time (some milliseconds).

Mode: Configure

Step

Command

Purpose

 

 

 

1

(config)#port fxo slot port

Enter FXO port configuration mode

 

 

 

2

(prt-fxo)[slot/port]#shut-

Shutdown the port. All active calls are dropped!

 

down

 

 

 

 

3

(prt-fxo) [slot/port]#no shut-

Activate the port.

 

down

 

 

 

 

Bind FXO ports to higher layer applications

An FXO port needs to be associated to an fxo interface in a CS context. The same mechanism of encapsulation and binding is used as known for e.g. ethernet ports (see section “Interfaces, Ports, and Bindings” on page 47).

Procedure: To bind an FXO port to an fxo interface of a CS context

Mode: Port FXO

Step

Command

Purpose

 

 

 

1

node(config)#port fxo slot port

Enter configuration mode for FXO port

 

 

 

2

node(prt-fxo)[slot/port]#encap-

Sets the encapsulation for the port. cc-fxo designs

 

sulation cc-fxo

the encapsulation is a context CS interface

 

 

 

3

node(prt-fxo)[slot/port]#bind

Binds the port to an interface in a CS context

 

interface interface

 

 

 

 

Introduction

543

Page 543
Image 543
Patton electronic SmartNode 4110 Series manual Shutdown and enable FXO ports, Bind FXO ports to higher layer applications