Patton electronic SmartNode 4110 Series manual Activate NAT/NAPT, Node cfg#context ip router

SmartWare Software Configuration Guide 11 • NAT/NAPT configuration

Activate NAT/NAPT

To activate a NAT/NAPT component, bind its NAPT profile to an IP interface. This binding identifies the global interface of the respective NAT/NAPT component. All other IP interfaces are local relative to this NAT/ NAPT.

Note If both a NAPT profile and an ACL profile are bound to the same IP inter- face, the ACL (Access Control List) acts on the local side of the NAT/ NAPT component.

Procedure: To activate a NAT/NAPT component

Mode: Configure

Step	Command	Purpose
1	node(cfg)#context ip router	Selects the IP router context
2	node(ctx-ip)[router]#interface	The NAPT profile shall be used on the interface name
	name
3	node(if-ip)[name]#use profile	Defines that the NAPT profile profile shall be used on
	napt profile	the interface name

Example: Configuring NAPT Interface

The following example shows how to activate a NAT/NAPT component with the NAPT profile access on the IP interface lan.

node(cfg)#context ip router node(ctx-ip)[router]#interface lan node(if-ip)[lan]#use profile napt access

Displaying NAT/NAPT configuration information

Two commands are available to display an existing NAPT profile. There is no command yet to display the dynamic entries of a NAT/NAPT component.

Procedure: To display NAT/NAPT configuration information

Mode: Configure

Step	Command	Purpose
1	node(cfg)#show profile napt	Displays the available NAPT profiles
2	node(cfg)#show profile napt	Displays the NAPT profile name
	name	or
	or	Displays the NAPT profile bound to the IP interface
	node(cfg)#show napt interface	name
	name

NAT/NAPT configuration task list 139